车库门噪音如何消除？噪声是什么原因造成？

How to eliminate noise from garage doors? What causes noise?

1、部件缺油

1. Parts lack oil.

在遥控车库门的导轨、平衡系统处和扭簧连接的传动部件少油时，运行的噪音也会很大，故而遥控车库门厂家建议大家要定期给传动部件、导轨添加润滑油，以保证门体的运行顺畅。

When there is less oil in the guide rail, balance system and transmission parts connected by torsion spring of remote control garage door, the noise will be very high, so the manufacturer of remote control garage door suggests that people should add lubricant to the transmission parts and guide rail regularly to ensure smooth operation of the door body.

2、螺丝松动

2. Screw loosening

遥控车库门合页、轨道等位置的固定螺丝松动也会造成噪音过大问题的出现，发生车库门噪音这时需要检查车库门固定合页和导轨的螺丝，看其是否出现松动，如有松动，要用老虎钳拧紧。

Location of remote control garage door hinge, track screw loosening will also cause excessive noise problems, garage door noise occurs at this time need to check the garage door hinge and guide screw, see if there is loosening, if there is loosening, to tighten with pliers.

3、安装不当

3. Improper installation

在安装遥控车库门时，由于没有保持在一个水平位置，一边门板靠近轨道，另一边则是远离导轨，这样以来在车库门门体上升过程中门板上的铰链和导轨之间摩擦力增大，就会产生吱吱的噪音。排除时，可以通过调整车库门两侧导轨来保证车库门门板在两侧导轨正中间，如此便不会产生车库门噪音过大问题了。

When remotely operated garage doors are installed, they are not kept in a horizontal position, one side of the door panel is close to the track, the other side is far away from the guide rail, so that the friction between the hinges on the door panel and the guide rail increases during the garage door body rising, and the squeaking noise will be generated. When excluded, the garage door can be adjusted to ensure that the garage door panel is in the middle of the two side guideways, so that no garage door noise problem.

4、磨损严重

4, serious wear

车库门运行滚轮上面塑料脱落、损坏、滚轴磨损严重会导致门板倾斜，倾斜后运行噪音也会变大。因此要定期更换运行滚轮，一定要全部更换。

The plastic shedding, damage and severe wear of the rollers on the running rollers of the garage door will cause the door plate to tilt, and the running noise will increase after tilting. Therefore, it is necessary to replace the running rollers regularly.